Problem With Sun Light On A Garage Door Openner

Light bulb needs to be replaced in garage door opener.

Problem with sun light on a garage door openner.

If you find that other lights or electrical circuits in the garage aren t operating this is the likely cause and you ll need to reset the breaker or gfci or replace the burned out fuse. Garage doors sometimes seem to have a mind of their own often deciding when and how far they want to open or close. Garage door sensors use infrared light. If you have an older model opener a cheap doorbell button might work.

If your garage door opener light is not working the fix might be as simple as changing the light bulb. It s important to get this switch at just the right distance from the motor so that the door is able to close all the way but the motor also knows to stop running. More and more products are being produced at a faster rate and that leads to reduced quality. T his is a pretty uncommon problem but one that can happen after you ve first installed your garage door opener.

If the opener runs you have a bad switch. This is related to the up limit switch. As soon as the door passes the sensors line the sunlight won t interfere with the beam anymore and the door will remain shut. Put a tube on the electric eye on each side of the garage door one side for mornings the other side for evenings 5 make sure the tube is extending straight out from the electric eye.

When the lumens of light from the sun surpass that of the infrared sensor light the sensors are not able to signal one another this is why a garage door might stop closing if strong sunlight is shining on the eye of a garage door sensor. Garage door fix to allow it to close when the sun is hitting the electric eye which makes it so the eye will not allow the door to go down note. A new one should cost you about 15. We have observed brand new light bulbs that don t work right out of the box.

If it isn t it could get in the way of the electronic beam and prevent the garage door from closing because the cardboard tube is breaking the beam. Another thing you can do to overcome this problem permanently is to set a cylinder shaped object around each of the sensors eyes which will block the sunlight and prevent it from interfering with them. Sometimes the fix can be as simple as replacing the batteries in the opener. Try making small adjustments.

The sun also carries infrared light which is more powerful than the light of the sensors.