A drip edge is a piece of roof trim which directs water into the gutters ensuring that water ends up where it is supposed to go as it drains from the roof.
Purpose of drip edge on roof.
Drip edges are metal sheets usually shaped like an l installed at the edge of the roof.
Also called drip edge flashing or d metal they serve a vital function by directing water away from the fascia and into the gutter.
With moisture accumulation being a factor with shingle deterioration it is important to locate the drip metal edging where the moisture can be quickly eliminated which is at the eaves or edges of the roof that overhang a supporting structure.
Optional for years drip edge is now required by the international building codes.
The primary objective of this drip edge is to keep the rain water from soaking up under the roofing shingles and causing dry rot of the plywood under the felt paper.
In others it is needed.
It is ironic that contractors who leave out the metal drip edge in an effort to save money lessen the long term value of a home.
It is required by the 2012 international building codes ibs for shingle roofs and you should make sure that it s properly installed with any new roof you get.
A drip edge is a non staining and non corroding material applied on a roof s edge to give water the ability to filter out of the roof system.
They extend beyond the fascia and are a minimum of one third of the gutter width.
In some homes a drip edge is not necessary because of the way in which the roof is designed.
The gutters then carry this water away.
Drip edge is a metal flashing that tends to overhang the sides of a roof.
The purpose of a drip edge is to help redirect water from the fascia and into the gutters.
It has the main function of controlling water flow on the roof which has many implications.
In other words it is the metal flashing located at the edge of a roof.
Roof drip edges perform a very important function.
They collect water from the roof and allow it to run off via the edging rather than down the fascia or the siding of the house.
This should point out to builders to specify install and insist on adequate metal drip edge to give residential clients the most value for a relatively low cost item.
A drip edge is an angled piece of flashing that is installed over top of a fascia board.
Drip edges can be installed on the rake eaves and gable of your roof.
There is a small size metal rim facing outwards and away from the roof fascia.
Many times roof shingles are installed to extend from 3 4 to 1 past the edge of the roof.
Although it does not look like much this component is made to have great structural integrity.
